Presetter machine software update

WASP PRESETTER

WASP

PAY ATTENTION!

The BIOS updating is a very delicate operation that requires the presence of skilled operators as a matter of PC procedures. If wrongly or not completely carried out, the required operations could damage the preset. In the case these operations have negative result, please repeat this procedure starting from the beginning.

The BIOS updating may require to delete the WASP digital read-out memory content.
When you finish to upgrade, verify the axes origin and the "calibration of the vision system" parameters (see par. 8.9.1 of the Instructions Manual).
Updating your preset software (BIOS) means to have always available the most tested and reliable version.

In order to run the updating, it is necessary to link the Preset to the PC by using a “Laplink “ standard serial cable "Laplink" (DB9 female pin connector - DB9 female pin connector).
  • First of all, please check which software version is installed on your presetter machine: it appears on the LCD screen for about 3 seconds at the machine starting (see figure):
Versione SW WASP
  • Click the "BIOS_WASP.exe" button to download the WASP presetter machine latest software version for free and install the file on your PC connected to the presetter machine
  • Afterwards, download and install the "wasp_31B-107.BIO" file
  • ATTENTION: It's necessary to authenticate yourself with User Name and Password. If you are not registered yet, fill in the form by clicking on "Register" button
  • If you have lost the registration datas, send an e-mail to "customer-care@elbocontrolli.it" to receive the new credentials

Follow us on:

📞 +39 0362 342745
📠 +39 0362 342741
🏚Elbo Controlli Srl Via San Giorgio 21 20821 Meda (MB) Italia